Waterborne Cold Lamination Adhesive AA600

Waterborne Cold Lamination Adhesive AA600 is a specialized adhesive for paper-to-plastic lamination.
It features high solid content, strong powder-covering ability, and reduced adhesive consumption.
It is suitable for prints with moderate powder spraying and higher bonding strength requirements.

Technical Specifications

Printed materials must be completely dry before lamination.
Use BOPP films with a corona treatment level ≥38 dyne, and ensure the treated sideis coated with adhesive.
Clean the coating roller before use to ensure no residual adhesive or contaminants.
Apply adhesive evenly to avoid insufficient coating or snowflake-like bright spots.
For powder-sprayed prints, it is recommended to remove the powder before lamination and use a powder-covering adhesive.
After rewinding, wait until the laminated surface becomes transparent and free of cloudiness before slitting.
For new printed materials or different adhesive batches, always conduct a trial lamination before mass production.

Do not add water or mix with other adhesives.
Store away from direct sunlight, heat, and freezing. If frozen, thaw slowly at room temperature and filter before use.
Keep sealed to prevent skinning and mold.
Avoid prolonged downtime during operation to prevent adhesive drying on rollers.
For gold/silver card prints, conduct a trial lamination and leave it for 24 hours to ensure no discoloration.
Avoid using strong alkaline adhesives for mounting or laminating onto corrugated board to prevent delamination, bubbling, or other defects.

There are no reviews yet.

Be the first to review “Waterborne Cold Lamination Adhesive AA600”